Choosing an electric winch starts with the load, not the vehicle’s weight alone. Estimate the force needed to move the load, including slope, rolling resistance, and obstacles. For example, a 1,800 kg load on a 10% slope, with an estimated rolling-resistance factor of 0.03, needs about 2,300 N (520 lbf) before extra losses. The estimate assumes steady movement. Mud, soft ground, or a stuck wheel can change it sharply.
For a preliminary check, apply a 1.5 safety allowance: 520 lbf becomes roughly 780 lbf. This is an example, not a universal standard; the right margin depends on the terrain, load control, and consequences of failure. Check the winch’s rated line pull at the actual drum layer, since capacity can fall as rope builds up. Include pulley losses if using a snatch block. Small details matter.
ASME B30.7-2021 addresses winch design, inspection, and operation, while OSHA 29 CFR 1926.251 requires rigging equipment inspection before use in applicable construction work. Neither replaces a site-specific load calculation. I would recheck the numbers if the load may roll, snag, or enter water; those assumptions are easy to miss.